28cm Bruno Neu K (E) 3D printed/new Kit

[EPOCH3]

These are some of the smaller detail parts I "printed".
The larger nuts are about .8 mm in dia (the head) and the
small bolts are even smaller (hard to get a good pic with the phone camera).

Btw these were printed on my little photon printer ($238)

[EPOCH3]

some progress updates -

[Tesla81]

Hi EPOCH3, im new to the forem so please excuse me if i ask something you have been asked a million times.

I am in the planning stages of building a 1/8 (7.25" gauge) scale replica of the S/K L40 Bruno that was captured by the Australian Army on 8 August 1918 outside Amiens, i am having trouble finding anything other than side elivation drawings.

I have contacted every museum and historical society in Australia that may have any information and have obtained a detailed record of the transport of it from france to Australia with some tecnical drawings .

I have contacted some museums snd people outside Australia including thyssenkrupp but have had no luck.

Are you able to point me in the rite direction to find anyone or anywhere that could help with more detailed information?

[EPOCH3]

Hi - just a few updates to the 28cm Br N K (E) as being built by
Billie Jean Debekker - awesome model

[EPOCH3]

And now Br N K (E) in 1/16th scale
Billie 's workbench is a bit more organized then mine (ha ha)

[Eax-E]

You are delightfully sick !
Good luck and please keep on sharing us news about your work !