15cm K 16 Krupp (for 3D printing)

Discussions on historical model building of all eras.
EPOCH3
Member
Posts: 641
Joined: 30 Jul 2006 22:22
Location: RI USA

15cm K 16 Krupp (for 3D printing)

Post by EPOCH3 » 17 Jul 2023 19:28

Finally getting around to finishing up my Krupp 15cm K16 which
is to be 3D printed in 1/35th scale. I might also do in 1/16th
scale. Will post some pics as they become physical
You do not have the required permissions to view the files attached to this post.

EPOCH3
Member
Posts: 641
Joined: 30 Jul 2006 22:22
Location: RI USA

Re: 15cm K 16 Krupp (for 3D printing)

Post by EPOCH3 » 27 Jul 2023 14:46

Decided to do in both 1/35th scale and 1/16th scale - here are a few wip pics of the first parts for the 1/16 rohrwagon.
Shown are two printers worth of parts that I printed overnight - printers are Anycubic Mono 4K X (a bit older ones bought used off ebay) and
print times were and 10 hours each at medium resolution. The surface of the barrel is really quite nice for such a large print. Parts are as printed (not cleaned up or post build cured yet)
You do not have the required permissions to view the files attached to this post.

EPOCH3
Member
Posts: 641
Joined: 30 Jul 2006 22:22
Location: RI USA

Re: 15cm K 16 Krupp (for 3D printing)

Post by EPOCH3 » 01 Aug 2023 18:16

....... and a few hours later.
Only 22 parts. This was a quick print in medium
resolution so after finding a few fit issues the model will be revised
and corrected and then it's ready to reprint at higher res.
You do not have the required permissions to view the files attached to this post.

User avatar
kstdk
Member
Posts: 5439
Joined: 10 Jan 2004 16:59
Location: Denmark

Re: 15cm K 16 Krupp (for 3D printing)

Post by kstdk » 01 Aug 2023 19:41

Hello

Just....Damn nice :-)

Regards
Kurt
kstdk

Return to “Model building”